How To Use SUCA Tapetool Plant Tying Machine

The SUCA Tapetool Plant Tying Machine is a new and efficient agricultural machinery product, used to bind and fix the branches and vines of crops, fruit trees, flowers, etc. It can quickly and effectively complete the work of tying branches, improve work efficiency, reduce labor costs, and at the same time ensure the health and growth of plants.

How To Use SUCA Tapetool Plant Tying Machine

The plant tying machine usually consists of a branch binding head and a bracket. It uses the power of the machine to tie the branches of the plant to the bracket with special tape and nails to keep the plant in good shape and growth.

Compared with the traditional manual binding method, the tapener tape tool can greatly improve work efficiency, reduce labor intensity, and avoid plant damage caused by improper manual binding. The garden tape tool has a wide range of uses and is suitable for tying and fixing branches of various flowers, vegetables, fruit trees, vines and other plants that require bracket cultivation.

 

suca tapetool set

 

HOW TO LOAD TAPETOOL  STAPLE

1. Hold the device with left hand, push up the knob of the pusher unit with right hand and pull it out backwards (Fig. A).

2. Pick up the staples with right hand and load them into the magazine unit with the staple legs pointing downward and set them in the pusher unit. You can load 200 staples of 604C type (Fig.A).

HOW TO OPEN TAPE HOLDER

Put your finger on upper part, then open the cover with the thumb pressing the upper part.

HOW TO LOAD TAPETOOL TAPE

1. Open the tape holder cover, load the tape as shown and close the cover until it “snaps” (Fig. A).

2. Set the tape while holding the head of the A-type handle unit with left hand and pull the tape downward with right hand.

 

HOW TO PULL OUT TAPE

1.Grasp handle so that the tape catcher will catch the tape end (Fig.B).

NOTE: After the tape catcher has caught the tape end, do not press the handle
harder.

2. Release the handle. The tape will be pulled out (Fig. C).

3. In case the tape catcher does not catch the tape when you grasp the handle, press the handle harder several times until the tape is caught.

Tapetool Instruction Manual

HOW TO BINDING OBJECTS

1. Press the tape against the object until it is positioned inside the tapetool (Fig. D).

2. Press the handle fully with the tape positioned centrally and the object will be bound with both tape and staple. Simultaneously the tape will be cut off.

HOW TO CHANGE TAPETOOL BLADE

1. When the blade becomes worn and not sharp enough to efficiently cut the tape, it should be replaced with a new blade.

2. Clip the fore-end of A-Type handle unit and magazine unit with left hand, pull out the old blade with nippers or pincers and insert a new blade. Handle with care to avoid damaging the edge of the blade.

NOTE: As the blade is extremely sharp, its handling must be done with care to avoid injury during replacement. When a new blade is needed, contact the distributor. (Fig.E)

 

HOW TO CORRECT STUCK STAPLES

Dismount pusher unit and remove the staples loaded. Remove the staples with a steel wire or a small screwdriver. (Fig.F)

 

You can also tie the knot manually using tape

One of the great things about this tape is that it stretches as the plant grows. And it’s wide so it won’t shrink and damage growing plants. So if you don’t have a lot of plants to tie up, you can just buy tape and forget about the cost of a stapler and staples.

Simply wrap around the stem, keeping it flat, then wrap around the stake and tie a knot with your hands. Make branches grow horizontally to produce more fruit. It’s great because you only have to do it once and since the tape won’t damage what you’re tying.

0 replies

Leave a Reply

Want to join the discussion?
Feel free to contribute!

Leave a Reply

Your email address will not be published. Required fields are marked *